Agenda

System overview  Universal Relay hardware overview    - Block diagram    - SCAN    - Specifications and hardware configuration    - Trip and close voltage and current      monitoring    - Mechanical installation and wiring  Options and ordering  Keypad operation lab exercises  EnerVista setup software    - Creating an interface, device and site		Settings    - Password security    - User programmable LED lab    - AC inputs: current and voltage    - Power system    - Signal sources    - Breakers    - Curves and flex curves    - Digital input and outputs    - Commands    - Actual values    - Status and metering group lab

Introduction to FlexLogic™    - Gates: AND, NAND, OR, NOR, NOT,      XOR, LATCH, positive edge triggered      one-shot, negative edge triggered      one-shot, dual edge triggered one-shot    - FlexLogic™ lab  Oscillography and event log lab  Saving/loading settings files

Protection and control    - Grouped elements    - Sources    - Operation and integration of the      following platform protection elements    - Lab: Testing of phase IOC (50)/phase      TOC (51) and voltage restraint    - Lab: Reclosing (79)		Firmware updates  Specifications, installation and basic testing of RS232, RS485, 10BaseT and 10BaseF data communications LANs  Emphasis on practical hands on lab exercises  Diagnostic messages and troubleshooting procedure
Where possible hands on lab exercises involving protection elements will include the injection of single-phase voltage and current to simulate faults and students will review event and oscillography records to verify protective element operation.